In a Nutanix cluster, a Protection Domain contains 50 entities that are replicated to a remote Single Node Replication Target.
The current schedule configuration is as follows:
* Repeat every 6 hours
* Local Retention Policy 1
* Remote Retention Policy 8
* Starting time 12 am
At 8 am on Monday, the administrator discovers that a protected VM is corrupted. The latest good state was Sunday 2 pm. The administrator needs to maintain current protection.
Which strategy should the administrator use to meet these requirements?

• A. From the local site, retrieve the correct remote snapshot, then restore the VM locally.
• B. From the local site, restore the VM from the local snapshot by selecting the correct snapshot.
• C. From the Remote site, activate the Protection Domain, then re-protect the entity.
• D. From the Remote site, restore the VM from the local snapshot by selecting the correct snapshot

An administrator is updating disk firmware using LCM and receives the following message:
"there have been 10 or more cluster services restarts within 15 minutes in the Controller VM" The message appears as each drive is upgraded.
What is the reason this message is being generated?

• A. A node has been rebalanced
• B. A node has been rebooted
• C. A drive has been reformatted
• D. A drive has been ejected

A new Nutanix cluster is ready for production on a remote site with no IT staff. Changes to the infrastructure will cost money and probably cause a cluster stop. The administrator needs to perform a health check on the environment that should include:
* Network connectivity checks
* Network performance status
* Storage performance status
Which tool should be used to perform this test?

• A. X-Ray
• B. clurator_cli
• C. diagnostic, py
• D. NCC

A Nutanix cluster is deployed with the following configuration:
* Three four-node blocks (A, B, and C)
* All Flash Redundancy Factor 2
What is the effect of simultaneous disk failures on two nodes located in block A?

• A. VM read and write operations continue normally.
• B. VMs are migrated off of the nodes with disk failures.
• C. Each node with a failed disk is marked as degraded.
• D. VMs on the nodes with failed disks are unable to write data

An administrator has two clusters: Site A and Site B.
Async DR is configured between the clusters as follows:
* Site A is the Primary Site
* Site B is the Secondary inactive Site, no VMs running
* Site A is fully in Production
* Site B used as Backup/Disaster Recovery
The customer wants to perform a planned failover between the sites.
How should the administrator accomplish this?

• A. Choose Migrate on the Secondary site within the Data Protection Dashboard
• B. Choose Migrate on the Primary site within the Data Protection Dashboard
• C. Click Activate on the Secondary site and run deactive NCLI command on Primary site
• D. Click Activate on the Secondary site within the Data Protection Dashboard